background image

Manual For WDG720M 
SAMSUNG ELECTRONICS CO., Ltd. 

 
Wi-Fi module(2.4GHz, 5GHz, a/b/g/n)

 

- Model name : WDG720M

 

- Operation Temperature : -10℃  ~ +70℃ 
- Power : +5V  ±5% (+4.75V ~ +5.25V) 

 
1. Introduction 

WDG720M is a USB embedded module compliant with IEEE802.11n standard. 
Thecore chipset is from MTK, part number is RT3572L. 

 

2. Operational Description 

WDG720M is the 802.11a/b/g/n RF Module, that acts as a communication hub for users of a 
wirelessdevice to connect to a wired LAN.   

 
MIMO type 

Product type: WLAN (

11b mode: 

1TX, 1RX, 

11g mode: 

1TX, 1RX, 11

n mode: 

2TX, 2RX) 

 
Time base of the transmission frequency 

For IF and RF frequency, Crystal is a clock reference. 

 
Synthesizer 

Synthesizer inside Transceiver. Internal voltage controlled oscillator (VCO) provides the desired 
LOsignal base on the phase-locked loop (PLL) with a relatively wide tuning range for this 
application. 

 
Transmission 

Base-band Processing (BBP) IC has DSSS (BPSK/QPSK/CCK) and OFDM 
(BPSK/QPSK/16QAM/64QAM) modulation function, it provides transmission data rate are 1, 2, 
5.5, 11Mbps on DSSS and 6, 12, 18, 24, 36, 48, 54 Mbps on OFDM. Digital data signal will be 
converted toanalog (TX IQ) signals through DAC in 

BBP 

IC, TX IQ pass through to low pass 

filter. TX I/Q signaluse direct conversion (zero-IF) architecture converter to generate carrier 
frequency signal. 

Transceiver

IC and internal PA magnify output power. 

 

 

Содержание WDG720M

Страница 1: ...ency For IF and RF frequency Crystal is a clock reference Synthesizer Synthesizer inside Transceiver Internal voltage controlled oscillator VCO provides the desired LOsignal base on the phase locked loop PLL with a relatively wide tuning range for this application Transmission Base band Processing BBP IC has DSSS BPSK QPSK CCK and OFDM BPSK QPSK 16QAM 64QAM modulation function it provides transmis...

Страница 2: ...ing data transfer base on the optimization of driver Discontinue Transmitting with absence of Data or operational failure states The device shall automatically discontinue transmission in case of either absence of information totransmit or operational failure These provisions are not intended to preclude the transmission of controlor signaling information or the use of repetitive codes used by cer...

Страница 3: ...rference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is co...

Страница 4: ...ne ou un autre émetteur Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes 1 L antenne doit être installée de telle sorte que 20 cm est maintenue entre l antenne et les utilisateurs 2 Ce module ne peut pas être co localisé avec d autres émetteurs ou des antennes Aussi longtemps que deux conditions précitées sont remplies le test du transmetteur supplémentaire...

Отзывы: