&
)
'
*
(
+
BN68-02401C-01
&
)
'
*
(
+
BN68-02401C-01
Quick Setup Guide
Before attaching the stand, place a soft cloth on a flat ,table surface, and then place the product onto the cloth so that the screen
is facing downwards.
&
)
'
*
(
+
BN68-02401C-01
Turn the stand in the direction
indicated by the arrow.
Caution:
Do not remove the stopper
pin before completely installing
the stand’s base. Otherwise it may
cause physical injury.
Turn the connecting screw at the
bottom of the stand fully so that it
is completely secured.
After installation of the base is
complete, stand the product up.
Remove the stopper pin.
•
Adjust the height of the screen
•
to your specifications.
Make sure that the stand has
been properly turned in the right
direction.
Push the base into the product’s
stand in the direction indicated by
the arrow.
Caution: 1. When placing the product on a flat surfacey you can damage the projection on the camera.
2. To prevent damage, place the monitor down gently & carefully.
3. Do not remove the stopper pin before installing the base.
Package Contents
Installing the stand
Installing the stand
Unpack the product and check if all of the following
contents have been included. Store the packaging box
in case you need to move the product at a later stage.
Refer to Setup and Configuration Guide clip found on:
www.radvision.com/VC240Setup
&
)
'
*
(
+
BN68-02401C-01
How to setup and configure your unit
&
)
'
*
(
+
BN68-02401C-01
