9
SPEED DOME CAMERA ACCESSORIES
8
SPEED DOME CAMERA ACCESSORIES
Installation Guide
1. Use the four screws found in the same packaging as the wall
type mount(STH-270PWV) as illustrated to secure the
bracket on where the speed dome camera is to be installed.
The STH-330POV is an STH-330PIV (Indoor housing) with a cooling fan and heater added. The STH-
320PO (Outdoor housing) is a lightweight model. (Both indoor and outdoor housings shall be referred
to as the "housing" from here on)
STH-330POV/320PO(Outdoor Housing), STH-330PIV(Indoor Housing)
2. Pull outside of the housing the safety cable
fastened to the housing.
3. Connect the fan-heater PCB connector of the camera holder to the
fan-heater PCB attached to the inside of the housing. (Applicable only
to indoor housings)
4. Match the arrow sign marked on the camera holder to the arrow marked
inside the housing and then install the camera holder in the housing.
5. Check that the fan cable attached to the housing dome cover and the
heater cable attached to the inside of the housing are connected to the
fan-heater PCB. If not, make sure they are connected. (Applicable only
to outdoor housings/Products are sold with the cables connected)
• Pull the connection cable out of the wall type mount through the hole in
advance.
Caution
Arrows
marke
Camera Dome Cover
Housing Cover
6. Adjust the direction of the camera by aligning the two
arrows at the bottom of the camera body, and then
mount the camera body on the housing
7. Aligning the arrows, insert the protrusion on the bottom of the camera
into the fixing hole inside the housing. Turn the camera body
clockwise to fix the camera and fasten the locking screw.
8. Remove the camera dome cover from the camera body, position the housing cover, and then fasten
the 4 screws attached
9. Connect the housing safety cable to the fixture
inside the mount(STH-270PWV) installed on
the Wall.
Safety cable
Wall Type
Mount
Indoor/
Outdoor
Housing
