Samsung SNK-D5081, Руководство пользователя

Страница: 25 / 80

25
3.2.2.3 Mainstream/Substream/Mobilestream
Go to “Main Menu”→“Record”→“Mainstream/Substream/Mobilestream” to enter into the menu
interface.
3.2.3 Network
3.2.3.1 Network
Go to “Main Menu”→ “Parameter”→ “Network” to enter into the interface.
Select the type of network connection (PPPoE, DHCP, Static) and set Port, then user may remotely
control the monitoring, recording, playback or backup of the NVR through the network.
Mainstream, Substream and Mobile stream are the
three video streams of IPC. Mainstream is mostly used
for recording and the Substream and the Mobilestream
is mostly used for remote network monitoring.

Channel: Select a channel

Resolution: Set IPC resolution as required

FPS: Min 1 and max 20

Video Encode Type: H.264 or H.265

Bitrate Control: Dynamic and Statics

Bitrate Mode: predefined mode or user-defined
mode

Bitrate: Set IPC bitrate
Take DHCP as an example. In this mode, the
router automatically assigns IP address for the NVR.
After restarting the NVR or DHCP server, the IP
address obtained by the NVR may be different. As a
result, user should check the IP address and port
number for each remote access of the NVR. The
operation procedure is as follows:
1. Select DHCP, click Save and refresh the NVR.
Input Client Port and HTTP Port (the two values
must not be the same).
2. Set obtained IP address of the NVR and the
mapping port.
3. Remotely visit the NVR by IP address:
http://Public network IP: HTTP port number (such
as 00080)
http:// Intranet IP: HTTP port number (such as
00080) (Only available in the same LAN)
For PPPoE, Static and DHCP, after setting IP
address of NVR, the extranet port shall be
mapped on the router before visiting NVR
through public network.
Note: Save after setting to make effective. If
there are multiple NVR in a LAN, make sure their
MAC addresses are different.