appendix
PROBLEM
SOLUTION
<Motion detection> of <Event
setup> is set to <Enable>, but
no notification e-mail reaches me
even when an event had occurred.
y
Verify the settings in the following sequence:
A. Check <Data & Time> settings.
B. The <Motion detection> should be set to <Enable>.
C. Check if the <E-mail> option of <Event action setup> menu is
checked to use.
No signal is found at the Alarm
Output port even when an event is
generated.
y
Check alarm output port settings.
Cannot record into the SD memory
card.
y
Check if the memory card is defective.
y
Check if the write protection tab of the memory card is set to “LOCK”.
SD memory card is inserted but
the camera does not operate
properly.
y
Check if the memory card is inserted in the proper direction. Operation
of memory card that is formatted by other devices is not guaranteed with
this camera unit
y
Format the memory card again in <Setup>
<Event>
<Storage>
menu.
Cannot format the SD memory
card.
y
Check if the write protection tab of the memory card is set to “LOCK”.
92_
appendix
