Samsung SIR-4260, Руководство пользователя, Страница: 6 / 17

COLOR DOME CAMERA User’s Manual
10
COLOR DOME CAMERA User’s Manual
11
Installation
Installation
Adjust the panning and tilting, rotating while watching the monitor
1) Remove the dome cover and shield case from the main body by loosening
the three dome cover screws.
2) And then remove the main body from mounting bracket by the four main body screws.
Mounting Bracket
Main Body(Camera)
Dome Cover
73°
-170°
145° 195°
170°
Pan Base
Tilt Base
Rotate Base
• The installation should be done by qualified service personnel or sysytem
installers.
• If the ceiling material is not strong enough to hold the installation screws, the
camera may fall off. Reinforce the ceiling as needed.
• Take care not to drop the product during installation. Do not allow anyone to stand
below the installation area.
Notes
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 170° to each side direction and 340° on the whole.
• Tilt Base covers total 146° angle(73°to each side).
• Angle range of Rotate Base is the same as that of Pan Base. But One side
range is 195° and another is 145°
2) Methods of adjustment
• The case of wall installation
…
After mounting the camera on a wall, adjusting the panning angle so that the
camera can face the direction to monitor when tilting.
…
And then adjust the tilting angle by rotating the tilt base.
…
Loosen the rotate base hold screw and adjust rotate base for the best
monitoring.
…
Tighten the rotate base hold screw.
• The case of ceiling installation
…
After mounting the camera on a ceiling, adjusting the panning angle for better
monitoring area by rotating the pan base.
…
And then adjust the tilting angle by rotating the tilt base.
• When adjusting the rotating angle, loosen rotate base holding screw as following
Figure A. And then tighten it again.
• When adjusting the tilting angle, just grip the tilt base and adjust tilting angle.
• When adjusting the panning angle, loosen pan base holding screws as the
following Figure B. And then tighten them again.
• 2 LEDs are paned in case of control Tilt angle(73°) to maximum but it is no
difference of visibility range performance.
Notes
• In case of adjusting the tilting, do not take the lens for preventing physical shocks.
Please take the Tilt Base
Rotate Base Holding Screw
Pan Base Holding Screw (Color:Gold) Rotate Base Holding Screw