COLOR DOME CAMERA
User Guide
20
COLOR DOME CAMERA
User Guide
21
Operating Your Camera
OFF : Not being used.
3. Select a desired mode using the Function Setup switch and press the switch.
WDR
OFF
• Select
‘
WDR
’
to adjust the WDR LIMIT and LEVEL.
HLC(High Light Compensation) :
If the scene contains extremely bright light areas such as;
from car headlight, the light can mask out much of the
on-screen detail.
- DAY : In normal daylight conditions, the HLC is not
activated.
- NIGHT : lf a high light that is larger than a certain size is present on the screen,
HLC is activated to remove the high light.
- HLC : Enable a user to select a mask color of high light area from a picture.
- LIMIT : Adjust the WDR sensitivity by selecting LOW,
MIDDLE, or HIGH.
- LEVEL : Adjust the WDR brightness by controlling the
bar from 1 to 100.
• The WDR compensates for backlight more effectively than previous models, by
applying an optimum fusion ratio when combining the high speed shutter used in
bright areas and the low speed shutter used in dark areas.
• Since the following symptoms may occur according to the ambient illumination when
WDR is selected, set it to OFF.
❶
…
Color or screen changes unnaturally.
2
…
Noise appears in the bright part of the screen.
• Since the performance of the WDR function may be affected by the area of the bright part
of the screen, optimize the installation angle for the best WDR performance.
• If you increase LIMIT, the image may be distorted.
• In a dark environment, the HLC is only activated when a high light that is larger than a
certain area is present.
• The HLC is not activated in light or overly dark conditions.
•
If the Color Rolling symptom is occurred while using WDR function, change sync mode to
『
L/L
』
(For more information about SYNC function, refer to page 25.)
Notes
BLC : Enables a user to directly select a desired area from a
picture, and to view the area more clearly.
• Select
‘
BLC
’
to adjust the area to be enhanced and
enhancement level.
WDR : When there are both bright and dark areas at the
same time, this mode makes both areas distinctive.
Operating Your Camera
2. Select a desired mode using the Function Setup switch.
OFF : Deactivates SSNR so that noise is not reduced.
ON : Activates SSNR so that noise is reduced.
3. Set the SSNR mode to ’ON‘ and press the Function Setup
switch. Then you can adjust the noise reduction level.
This function reduces the background noise in a low luminance environment.
1. When the SETUP menu screen is displayed, select ’SSNR‘ by using the Function
Setup switch so that the arrow indicates ’SSNR‘.
SSNR
MAIN SETUP
1.LENS
DC
2.EXPOSURE
3.WHITE BAL
ATW
4.BACKLIGHT
OFF
5.SSNR
ON
6.DAY/NIGHT
AUTO
• You cannot set the SSNR to ‘ON’ or ‘OFF’ when the AGC mode of the EXPOSURE
menu is ‘OFF’.
• When adjusting the noise reduction level of the SSNR mode, remember that the higher the
level set, the more the noise level will be reduced but that after image may also occur.
Notes