Version 1.1
- 18 -
- BURST : If set to <OFF>, the burst signal will not be
output in NIGHT mode.
- DAY
→
NIGHT BRIGHTNESS : Specify the brightness level
switching from COLOR to BW filter. Adjusting from HIGH
to LOW will cause to switch the filter in a darker screen.
- DAY
→
NIGHT DWELL TIME : Time required to determine
the filter switch.
- NIGHT
→
DAY BRIGHTNESS : Specify the brightness level
switching from BW to COLOR filter. Adjusting from HIGH
to LOW will cause to switch the filter in a darker screen.
- NIGHT
→
DAY DWELL TIME : Time required to determine
the filter switch.
- MASK AREA : If there exists a bright spot light source in
a night scene, you can specify the size and position as
needed. This will prevent an error in switching filter, or
failure to determine the filter switch in a night scene
where a bright spot light source exists.
Any excessively bright area in a night scene will be
masked.
※
You can specify MASK 1 and 2 simultaneously.
※
If <BACKLIGHT> is set to <BLC>, the MASK AREA
function is not available.
●
WHITE BAL
If you need to adjust the color according to the ambient
illumination, you can use the <WHITE BAL> function.
- DAY : You can set the RED, and BLUE value in DAY
mode. The screen will be displayed in colors according
to your settings.
You can set the R-GAIN, and B-GAIN value only in
<AWC> mode.
- NIGHT : You can set the <WHITE BAL> according to the
ambient illumination. If NIGHT mode is set to <OFF>,
the <WHITE BAL> will operate in a mode specified in
DAY mode at all times; otherwise, the screen will switch
to a mode specified in <DAY/NIGHT>.
You can set the RED, BLUE and BRIGHTNESS value in
DAY mode. The screen will be displayed in colors
according to your settings.