Samsung PLK435W, Инструкция по эксплуатации, Страница: 36 / 64

Operation
34
Setting Up Your Remote Control
This TV’s remote control can operate almost any VCR or cable box. After it has been set up properly, your
remote control can operate in three different modes: TV, VCR or Cable. Pressing the corresponding button
on the remote control allows you to switch between these modes, and control whichever piece of
equipment you choose.
Setting Up the Remote to Operate Your VCR
1
Turn off your VCR.
2
Press the SET button on your TV’s
remote control.
3
Press the VCR button on your TV’s
remote control.
4
Using the number buttons on your
remote control, enter both digits of
the VCR code listed on page 36 of
this manual for your brand of VCR.
Make sure you enter both digits of
the code, even if the first digit is a
“0.”(If more than one code listed, try
the first one.)
5
Press the POWER button on the
remote control. Your VCR should turn
on if your remote is set up correctly.
If your VCR does not turn on after set
up, repeat steps 2, 3, and 4, but try
one of the other codes listed for your
brand of VCR. If no other codes are
listed, try each VCR code, 00
through 72.
1
2
3
4
5 6
8
0
SWAP STILL MENU
PIP CH.SCAN ASPECT
CH
S.STD MTS SURR. P.STD
TV VCR CABLE SET
TV/VIDEO ADD ERASE
STOP PAUSE
PRE-CH
SLEEP
REW PLAY
POWER
VOL
+100
7
DISPLAY
9
MUTE
FF
REC
VOL
LOCATE P.SIZE
PIP CH
NUMBER
BUTTONS
POWER
SET
VCR
LK435W(eng)US 11/29/00 10:41 M Page 34