C
HAPTER
T
HREE
: TV O
PERATION
3
.5
O
P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH
▲
and
CH
▼
buttons to scan through the channels. This eliminates the need to change channels
by entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press
MENU
to
display the menu.
2
Press
CH
▼
two times to
highlight “SET UP.”
Move
Exit
Ent.
±
SET UP
Channel set up
ANT / CATV
Time
Convergence
Language
Caption
V-chip
ANT
English
3
Press
VOL +.
The setup sub-menu will
appear. Press
CH
▼
to
highlight ANT/CATV.
Move
Sel.
Menu
±
SET UP
Channel set up
ANT / CATV
Time
Convergence
Language
Caption
V-chip
ANT
English
4
Repeatedly press
VOL +
to cycle
through these choices:
ANT (antenna)
STD, HRC or IRC (all cable TV).
Move
Sel.
Menu
±
SET UP
Channel set up
ANT / CATV
Time
Convergence
Language
Caption
V-chip
STD
English
Note: STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected. Proceed to “Storing
Channels in Memory” (next page).
00578C(E)-CHAPTER 3 7/3/00 4:40 PM Page 5