Samsung iDCS 500, Техническое руководство

Страница: 32 / 137

iDCS 500 Release 2 / OfficeServ INSTALLATION
TECHNICAL MANUAL PART 3 MARCH 2004
3.9
connectors, taking care to properly line them up and press gently on the back of the
board to seat it. The MCP2/LCP2/SCP2 case can now be reassembled if all required
daughter boards have been installed.
Note: The RCM board can only be installed on the MCP2 in an M version system.
3.9 MODEM BOARD (see Figure 3-14)
This board has no selectable options and installs on the IOM board (see Figure 3–15) .
The MODEM board provides a 56Kbps/V90 modem for communicating with the system
remotely. Place the modem board face down over the two connectors, taking care to
properly line them up, and lining up the holes in the MODEM board and IOM board,
and press gently on the back of the board to seat it.
3.10 IOM BOARD (see Figure 3-15)
This board has no selectable options and installs on the system main cabinet (see
Figure 3–16) . Line the IOM board up with the card slot and slide it in. Press gently on
the center of the IOM board front panel to seat it and secure the board with the two
screws.
3.11 TRUNK B CARD ( see Figure 3–17 )
This card has no selectable options. Insert as many Trunk B cards as are needed into
any universal slots
(see Figure 3–1) . Push firmly in the middle of both card ejectors on
each card to ensure that it is fully inserted into the back plane connector.
3.12 TRUNK B1 CARD ( see Figure 3–17 )
This card has no selectable options. Insert as many Trunk B1 cards as are needed into
any universal slots
(see Figure 3–1) . Push firmly in the middle of both card ejectors on
each card to ensure that it is fully inserted into the back plane connector.
3.13 TRUNK C1 CARD (
see Figure 3–17
)
This card has no selectable options. Insert as many Trunk C1 cards as are needed into
any universal slots
(see Figure 3–1) . Push firmly in the middle of both card ejectors on
each card to ensure that it is fully inserted into the back plane connector.
3.14 GTRK CARD ( see Figure 3–17 )
This card has no selectable options. Insert as many GTRK cards as are needed into
any universal slots
(see Figure 3–1) . Push firmly in the middle of both card ejectors on
each card to ensure that it is fully inserted into the back plane connector.
Home Page Table of Contents