Samsung ES1642dc, Руководство пользователя по оборудованию

Страница: 21 / 59

21
protect your data. RAID-TP requires a minimum of 4 drives.
Reset Button Behavior
Reset button: Press to reset the system settings.
System
Basic system reset
(1 beep)
Advanced system reset
(2 beeps)
All ES models 3 sec 10 sec
Basic system reset (3 sec)
Press the reset button for 3 seconds, a beep sound will be heard. The System administration
password will be reset to default.
Advanced system reset (10 sec)
Press the reset button for 10 seconds; you will hear two beeps at the third and the tenth seconds. The
settings such as the users and user groups previously created will be cleared. The ES NAS will reset all
the system settings to default as it would by using the web-based system reset in “Control Panel” >
“System Settings” > “Backup / Restore” > “Restore to Factory Default” > “Reinitialize NAS”.
However ,
resetting the ES NAS by holding the button, the data on the ES NAS will not be deleted.
Management port
The management is provided by Intel® 82579 Gigabit Ethernet controller. The management port allows
you to connect to the QES desktop of the ES NAS. The default ES NAS management website is
169.254.100.100:8080. If the ES NAS has been configured to use DHCP, you can use the QNAP Qfinder
Pro to check the IP address of the ES NAS. Make sure the ES NAS and the computer that runs the QNAP
Qfinder Pro are connected to the same subnet. The system requires that the management IP addresses
are configured on both controllers and that the controllers’ management ports are connected to the
management network. This should be a separate LAN or a VLAN because you should not use the
production LAN or VLAN for management network traffic. To configure the management port IP Address,
please refer to the software user manual.
In case that one Storage Controller fails, you can enable
takeover function from the High Availability app in QES to manage the system through the management
port of the other Storage Controller with the same IP address. For more information, please see the
software user manual.