18_
Using the detergent and water softener
Using the detergent and water
softener
Amount of detergent to use
1.
Fill the detergent dispenser with detergent.
The marking indicates the dosing levels, as illustrated on
right:
A.
This section is for main wash detergent, approximately
25 g
B.
This section is for the pre wash detergent,
approximately 5 g
If the dishes are heavily soiled, place an additional
detergent dose in the pre-wash detergent chamber. This
detergent will take effect during the pre-wash phase.
You can find information about the amount of detergent
for the single programmes on the “
Wash cycle table
”.
(See page 25)
Please be aware, that according to the soiling level and
the specific hardness of water differences are possible.
A
B
2.
Close the lid and press until it locks in place.
Please observe the manufacturers dosing and storage recommendations as stated on the
detergent packaging.
Detergents
There are 3 sorts of detergents.
1.
With phosphate and with chlorine.
2.
With phosphate and without chlorine.
3.
Without phosphate and without chloride.
Normally new pulverised detergent is without phosphate. The water softener function of
phosphate is not given. In this case we recommend to fill salt in the salt container even when the
hardness of water is only 6 dH. If detergents without phosphate were used in case of hard water
often white spots appear at dishes and glasses. In this case please add more detergent to reach
better results. Detergents without chlorine do only bleach a little. Strong and coloured spots will
not removed completely. In this case please choose a programme with higher temperature.
DD81-01624A-04_EN (Turkey)_150904.indd 18
DD81-01624A-04_EN (Turkey)_150904.indd 18
2015-09-04 3:16:18
2015-09-04 3:16:18
