Samsung DVG50R5400 Series, Руководство пользователя, Страница: 26 / 60

Installation
English 26
Installation
Vent blockage test
After the dryer is installed, start the Vent Blockage Test to check if the duct system is
properly installed. The Vent Blockage Test automatically detects the status of the ducts
and reports any blockage or problems. Proper ducting can reduce drying time and save
energy.
NOTE
The Vent Blockage Test must run with the dryer in a cool state. If the dryer warms up
after the installation check, run the
AIR FLUFF cycle for several minutes to reduce its
internal temperature.
Running the vent blockage test
1. Make sure the drum is empty, and then close the door. (If there are any clothes or
other items in the drum, the test will not give accurate results.)
2. Press the Power button to turn the dryer on, then simultaneously press and hold the
Adjust Time and Dry Level buttons for 3 seconds. “ InS or In ” appears in the dryer’s
display. (If you have started other procedures before the Vent Blockage Test, the dryer
will not enter the Vent Blockage Test mode.)
3. Press the Start/Pause (Hold to Start) button. The Vent Blockage Test starts immediately.
During the test, the number indicator makes a circle in 6 clockwise steps. The test takes
about 2 minutes. Do not open the door during the test.
4. After 2 minutes, when the test is complete, the results is displayed and the dryer
sounds a tone. If status of the duct system is normal, “ End or 0 ” appears and the
dryer sounds a completion tone. If the duct system can not exhaust properly, “ CLg
or Cg ” appears and the dryer sounds an alarm tone. If there are any other problems,
an information code appears in the display. For information about the code, see
“
Information codes ” section on page 48 .
- To stop or cancel the Vent Blockage Test, press the Power button to turn off your
dryer.
- During the test, if “ dc ” appears in the display, make sure the door is closed. If “ C1 ” is
displayed, see if there is laundry inside drum. If there is, stop the test and remove it.
Then, start the test again.
- The results remain on the display for about 5 minutes and then automatically turn
off. You can turn the result off immediately by pressing the Power button.
NOTE
• During or after the test, the internal drum is hot. Use caution to prevent burns. The
Vent Blockage Test is used to check for problems to the current duct system when the
dryer is installed for the first time.
Untitled-1 26 11/22/2018 12:10:51 PM