installing the hob _
13
INST
ALLING
THE
HOB
CONNECTING TO THE MAINS POWER SUPPLY
Before connecting, check that the nominal voltage of the appliance, that is, the voltage
stated on the rating plate, corresponds to the available supply voltage. The rating plate is
located on the lower casing of the hob.
Shut off power to circuit before connecting wires to circuit.
The heating element voltage is AC 230 V~. The appliance also works perfectly on
networks with AC 220 V~ or AC 240 V~.
The hob is to be connected to the mains using a device that allows the appliance to be
disconnected from the mains at all poles with a contact opening width of at least 3 mm,
eg. automatic line protecting cut - out, earth leakage trips or fuse.
The cable connections must be made in accordance with regulations and
the terminal screws tightened securely.
Once the hob is connected to the mains supply, check that all cooking zones are
ready for use by briefly switching each on in turn at the maximum setting with suit-
able cookware.
When the hob is powered on for the first time, all displays light and the child safety
lock is activated.
Pay attention (conformity) to phase and neutral allocation of house connection and
appliance (connection schemes); otherwise, components can be damaged.
Warranty does not cover damage resulting from improper installation.
If the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer or its service agent.
•
1N ~
•
2N ~ : Separate the 2-phase wires
(L1 and L2) before connection.
L
N
1N ~
N
2N ~
L1 L2
For correct supply connection, follow the wiring diagram attached near the
terminals.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
Brown
Black
Green/Yellow
Gray
220-240V ~
380-415V ~
Brown
Black
Green/Yellow
Gray
220-240V ~
CTN464NC01_XSA_DG68-00348A-01-EN.indd 13
13/10/2555 18:06:36
