Samsung Semiconductor, Inc.
ARTIK 053s Development Kit Hardware User’s Guide
8
ARTIK 053
S
S
TARTER
B
OARD
The ARTIK 053s Development Kits includes a Starter Board which connects to the Interposer board. This section is
divided into interface types and connector types on the Starter board.
Starter Board Interfaces
This section describes the various interfaces on the Starter board.
Power Interface
Power to the ARTIK 053s Starter Kit can be sourced from the micro-USB connector, a 5 - 12V DC Jack, or a 5.6 - 6.4V
battery.
shows the jumper settings to select each of the power sources. Note that pins 1 - 2 are located
closest to the edge of the board.
N/A
N/A
N/C
37
38
XPWM4_OUT
40
XPWMTOUT_4
N/A
N/A
N/C
39
40
N/C
N/A
N/A
N/A
N/A
N/C
41
42
GND
N/A
N/A
EXT_5V_12V
32
DC_5V_12V
43
44
GND
N/A
N/A
DC_5V_12V
45
46
GND
N/A
N/A
DC_5V_12V
47
48
GND
N/A
N/A
DC_5V_12V
49
50
GND
N/A
N/A
Table 4. Power Configuration Jumper Settings
CON705 Power Jumper
Connections
Power Source
Description
1 - 2
micro-USB (CON700)
Power is applied by the micro-USB connector. The pinout of the
USB connector is as follows:
Pin 1: VCC_USBP0 power
Pin 2: D-
Pin 3: D+
Pin 4: NC
Pins 5 - 11: Ground
3 - 4
DC Jack (CON712)
Power is supplied by the DC power jack. The pinout of the DC jack
is as follows:
Pin 1: 5V - 12V DC power
Pin 2: Ground
Pin 3: Ground
5 - 6
2-pin header (CON706)
Power is supplied by a battery connected to CON706 as shown
below. The pinout of the battery connector is as follows:
Pin 1: 5V - 12V external battery power
Pin 2: Ground
Pin 1 of the battery connector is not identified on the silkscreen but
rather by the square pad on the bottom of the Starter board. Pin 1 is
also shown in
Table 3. ARTIK 053s Interposer Board CON401 Connector Pinout and ARTIK Module Pin Mapping (Continued)
ARTIK Module
Connector CON400
ARTIK Module
Pin Name
Pin Number
Pin Name
Pin Number Pin Number
Pin Name
Pin Number
Pin Name
