CARD
Place the card or key tag on the card reader.
The door will be opened after 1 second.
This section contains important information to ensure the user’s
safety and prevent potential damage to property. Please, read
this section carefully and use the product accordingly.
Warning
The product components used may vary depending on the installation
environment.
All registered data (password, card, key tag) are deleted. After initialization, the
password is set to ‘12345’, and the registered card, key tag data are erased.
Please register a new password after initialization.
When the number pad is lighted, enter
‘4560852580’ and then press the [
] button.
- Success: Too~~~t
- Fail: Toot
1. Pressing the [Register] Button
(from the inside)
Press and hold the [Register] button
for 5 seconds.
SHS-H635
www.samsungsds-nss.com/en
GC68-02068B ED:01
USER MANUAL
Convenient Opening
- User friendly access with
cards and password
Graphic Interface
- Shows the operation status
of the doorlock
Double Authorization
- Requires card & password
combination to open
Double Locking
- Prevents opening from outside
(Do not disturb)
Built-in Fire Detection
- Generates alarm in case of a fire
Security Function
- Prevents intrusion from the outside
CARD
2
The door can be opened from outside using a card or key tag.
Place the registered card or key tag on the card reader.
Pulling down the Door Lock Handle
Rotate the manual Open/Close lever
to the right or left to lock the door or
release the locking.
Rotating the Manual Open/Close
Lever to the Right or Left
Rotate the door lock handle of the inner
body downward.
When purchased, the product is set to Multi-leveled Security Code Entry Mode
initially. Please refer to “Multi-leveled Security Code Entry Mode setting” for
Common Mode setting.
CARD
Safety Cautions
Product Components
• The user shall not install or repair the
product without authorization.
• Do not install the product in the place
where the gap between the door and the
frame is 5mm or more.
• Make sure that no unauthorized person
has the access to the password.
• Do not operate the product with wet
hands, and keep liquids such as water
or drinks away from the product, or
the product may malfunction or be
damaged.
• Do not use the excessive force or sharp
objects to push the lockbuttons, as this
can damage the product.
• Make sure that the door is completely
closed when going outside. The
manufacturer does not assume the
responsibility for any harm caused
by engagement of the lock on an
improperly closed door.
• Please do not hang on the product or
pull it.
• Be sure to correctly match the poles
(+/-) when installing the batteries. Install
the batteries with the correct poles (+/-).
• Long-term exposure to direct sunlight
may cause a crack on its touch pad.
Avoid exposure to direct sunlight during
installation.
• During battery replacement, use a new
one instead of the existing battery.
• Do not use water, benzene or alcohol
when cleaning the product, as these
fluids can cause product malfunction.
• Replace the batteries within 1 week
after the battery replacement alarm
sounds.
Number Pad Unlighted
Number Pad Lighted
Number Pad
Card Reader
Enter Number
Button
LED Indicator
Outer Body Handle
Battery Cover
Auto/Manual
Locking Switch
CLOSE Button
Manual Open-
and close
Lever
Sound Control
Switch
Inner body
Handle
Registration
Button
Outer Body Parts
Mortise
Emergency
Keyhole
Inner Body Parts
Opening the Door from Outside with a Password
Opening the Door from the Inside
●
Password must be entered after the light is on, and if does not, touch
[Number Pad] and re-enter.
●
To cancel, press [ ] button and re-enter.
●
If the password is wrong 5 times, “Toot~, Toot~, Toot~” warning alarm will
sound 20 times and the system will shut-down for about 3 minutes. When
malfunction happens, “Toot” will sound every 10 seconds, and stop mode will
be turned off automatically after 3 minutes with multiple ‘beeps’.
Note
Enter the password when the
number pad is lighted, and press
the [
] button.
2. Common Mode
Pressing the [Enter Number]
Button will light up the
number pad
Pressing the [Enter
Number] Button will
light up the number
pad
1. Multi-leveled Security Code Entry Mode
When two arbitrary
buttons are lighted,
press the buttons in
order.
When the numbers on the
number pad are lighted,
enter the password and
press the [
] button.
Success: Too~~~t
Fail: Toot
Opening the Door from Outside with a Card or
Key Tag
Closing the Door from the Outside
Closing the Door from the Inside
Closing the Door from the Inside
In the Manual Locking Mode
The door is locked when the [Close]
button is pressed, or the manual Open/
Close lever is rotated.
Initialization (Password, Card, Key Tag)
2. Entering the Numbers for
Initialization (from the outside)
Password Change
The password can be 5~12 digits number. Only one password can be registered.
Enter the current password (‘12345’ after
initialization) when the number pad is lighted,
and press the [
] button.
1. Pressing the [Register] Button
(from the inside)
Open the battery cover of the inner
body and briefly press the [Register]
button.
2. Entering the Current Password
(from the outside)
Enter the new password (5 to 12 digits)
and press the [
] button.
- To prevent burglary, it is recommended
to use a password of 6 digits or longer.
(Only numbers between 0 and 9 can
be used.)
3. Entering a New Password
(from the outside)
Enter the new password again to check if the
new password is accurately configured, and
then press the [
] button.
4. Reentering a New Password
(from the outside)
Placing the Card or Key Tag on the Card Reader
3
4
5
6
CARD
CARD
External Power
Port
Success: Too~~~t
Fail: Toot
Success: Too~~~t
Fail: Toot
Toot
→
Toot, toot
→
Toot, toot, toot, toot
Toot
Too~~~t
Too~~~t,
toot, toot
Too, Toot
Too~~~t
Pressing the [Enter Number ] Button
When you come out opening the door from the
inside in the Manual Locking mode, press the [Enter
Number] Button on the outer body.
The door is automatically locked
2 seconds after the door is closed.
SHS-AML320
SHS-AML220
CARD
CARD
Outer Body
Inner Body
Key Tag
User Manual
‘AA’ Batteries (LR6)
Emergency Key (5EA)
Handle Shaft
Handle Shaft Spring
• Support Panel and Inner
Body Fastening Bolts
• Support Panel and Outer
Body Fastening Bolts
• Inner Fastening Bolts
• Strike Fastening Bolts
Strike
box
Mortise
(SHS-AML220)
Strike
Mortise
(SHS-AML320)
Strike
Or
Deadbolt
Latch bolt
Open-door sensor
SHS-AML320
SHS-AML220
CARD
CARD
CARD