Samson Type 5824, Монтаж и эксплуатация

Страница: 28 / 64

5-6 EB 5824-1 EN
Installation
5.6 Electrical connection
Risk of fatal injury due to electric shock.
Î
Upon installation of the electric cables,
you are required to observe the regula-
tions concerning low-voltage installations
according to DIN VDE 0100 as well as
the regulations of your local power sup-
plier.
Î
Use a suitable voltage supply which
guarantees that no dangerous voltages
reach the device in normal operation or
in the event of a fault in the system or
any other system parts.
Î
Only perform the electrical connection
after switching off the supply voltage.
Make sure the supply voltage cannot be
switched on again unintentionally.
− Voltage applied to eL causes the actuator
motor to retract the actuator stem.
− Voltage applied to aL causes the actuator
motor to extend the actuator stem.
Risk of damage to the actuator due to in-
correct connection of the voltage.
Î
Do not apply a voltage to eL and aL at
the same time.
Wiring
Î
Guide the wires through the cable entries
into the housing and connect as shown
in Fig. 5-5.
Î
The interference suppression capacitors
in the output circuit of the connected con-
troller must not exceed a value of 2.5 nF
to ensure the proper functioning of the
actuator.
Î
Connect actuators operated in parallel
over separate contacts to prevent the ac-
tuators hunting in the end positions due
to a shared OPEN and CLOSED contact.
Î
Connect the supply voltage additionally
to terminals L and N in
Type 5825 .
DANGER !
NOTICE !