Samson TROVIS SAFE 3730-6, Монтаж и эксплуатация, Страница: 108 / 184

108 EB 8384-6S EN
Operating the positioner
7.6.4 MAN2 – Initialization based on manually selected end po-
sitions
Before starting initialization, move the control valve manually to the end positions. The posi-
tioner calculates the travel/angle difference from the positions that the valve moved to and
adopts it as the operating range with limits of lower travel/angle range value (Code 8) and
upper travel/angle range value (Code 9).
This initialization mode can only be started when the valve position differs in the end posi -
tions and the positioner has not yet been initialized.
Enable configuration:
Configuration is locked again if no settings are entered within 120 s.
1. Turn until Code 3 appears (reading:
No ).
2. Press , the code number 3 blinks.
3. Turn until
YES appears.
4. Press to confirm (reading: ).
Enable configuration
Default: No
Enter the pin position:
1. Turn until Code 4 appears.
2. Press , the code number 4 blinks.
3. Turn to select pin position on lever (see
relevant section on attachment).
4. Press to confirm.
mm
Pin position
Default: No
Select the initialization mode and enter end positions:
1. Turn until Code 6 appears.
2. Press , the code number 6 blinks.
3. Turn until
MAN2 appears.
Init mode
Default: MAX
Note