Samson TROVIS SAFE 3730-6, Монтаж и эксплуатация, Страница: 105 / 184

EB 8384-6S EN 105 EB 8384-6S 105
Operating the positioner
7.6.2 NOM – Initialization based on nominal range
The calibrated sensor allows the exact valve travel to be measured very accurately. During
initialization, the positioner checks whether the control valve can move through the indicated
nominal range (travel or angle) without collision. If this is the case, the indicated nominal
range is adopted with the limits of travel/angle range start (Code 8) and travel/angle range
end (Code 9) as the operating range.
The maximum possible travel must always be greater than the rated travel entered. If this is
not the case, initialization is automatically canceled (error message Code 52) because the
rated travel could not be achieved.
Enable configuration:
Configuration is locked again if no settings are entered within 120 s.
1. Turn until Code 3 appears (reading:
No ).
2. Press , the code number 3 blinks.
3. Turn until
YES appears.
4. Press to confirm (reading: ).
Enable configuration
Default: No
Enter the pin position and nominal range:
1. Turn until Code 4 appears.
2. Press , the code number 4 blinks.
3. Turn to select pin position on lever (see
relevant section on attachment).
4. Press to confirm.
mm
Pin position
Default: No
5. Turn until Code 5 appears.
6. Press , the code number 5 blinks.
7. Turn and set rated travel of the valve.
8. Press
to confirm.
mm
Nominal range
(locked when Code 4 =
No)
Note