q
Deactivate the function block.
Display shows:
F__ - 0
Confirm settings.
If the function block is not closed, further function block parameters can be adjusted.
Proceed as follows:
Make the desired changes and confirm.
If applicable, the next function block parameter is displayed.
Confirm all parameters to exit the opened function block.
To adjust additional function blocks, repeat the steps in the fields highlighted in gray.
q
Select
End
.
Exit configuration level.
q
Select
End
.
Return to operating level.
2.3
Changing parameters
Depending on the set system code number and the activated functions, not all parameters
listed in the parameter list in the Appendix (–> section 12.2) might be available.
The parameters are grouped by topics:
4
PA1: Heating circuit 1/primary heat exchanger circuit
4
PA2: Heating circuit 2/supplementary heating circuit
4
PA3: Not used
4
PA4: DHW heating
4
PA5: Parameters for various systems
4
PA6: Communication parameters
4
PA7: Not used
4
PA8: Not used
EB 5576 EN
23
Start-up
