1.7
Setting the party mode
Using the
Party mode
function, the controller continues or activates rated operation of the
controller during the time when the party timer is active, regardless of the programmed
times-of-use. The party timer begins when the rotary switch has been returned to operating
mode
“Automatic“. When the party timer has elapsed, the party function is reset to
00:00.
The party modes for the different control circuits are set at the rotary switches
one after the
other
:
Party timer
Rotary switch
Position
Heating circuit 1/primary heat exchanger circuit
Top
Heating circuit 2/supplementary heating circuit
Middle
DHW circuit
Bottom
Parameter
WE
Range of values
Continue/activate rated operation
0 h
0 to 48 hours
Proceed as follows:
Turn appropriate rotary switch to “Party mode“.
Display shows:
00:00
or the remaining time of the party timer
q
Edit desired length of the one-off time-of-use.
Return the rotary switch to operating mode
“Automatic“ (left side).
Note!
Elapsing of the party timer is displayed in steps of 15 minutes.
14
EB 5576 EN
Operation
