Samson SAM HOME, Монтаж и эксплуатация

Страница: 29 / 82

EB 5660 EN 6-1
Start-up
6 Start-up
The SAM Gateway Configurator tool (see the 'Configuration with SAM Gateway Configura -
tor tool' section) installed on a computer as well as a patch cable are required to start up the
SAM HOME Gateway.
In the delivered state, the SAM HOME Gateway is configured for communication over the
Ethernet interface including an automatic function to switch between
DHCP client and DHCP
server. The DHCP client function remains active for around one minute after the device is
switched on. If the SAM HOME Gateway does not receive an IP address from a DHCP server
during this period, the device starts to function as a DHCP server with the configured IP
address (default setting: 192.168.55.2).
6.1 Setup for use with SAM DISTRICT ENERGY web portal
How to proceed:
Î
Connect the SAM HOME Gateway to the supply
voltage.
The power LED is illuminated when the supply
voltage is connected.
LED Status
Power ON
Portal Any
LAN port Blinking
Î
Use a patch cable to connect the computer to the SAM HOME Gateway (LAN port).
Î
Open the SAM Gateway Configurator tool installed on the computer. Perform a scan
and select the gateway you require by double-clicking it.
Î
Configure the following settings in the indicated order:
− IP address (DHCP/static IP)
− M-Bus configuration
−
Modbus settings
− Optionally: error alarms
After saving the configuration settings, the SAM HOME Gateway automatically re -
starts.
Î
Disconnect the computer from the SAM HOME Gateway.
Note