Samson Conert 277, Руководство пользователя

Страница: 8 / 16

4
1: MIX OUT switch
- Sets the OUTPUT B balanced output to send either the combined signal for
Channel A and B when the switch is in the "ON" position, or to just Channel B when in the "OFF"
position. See the “Setting Up and Using the Concert Series System” section on page 6 in this
manual for more information.
2: OUTPUT B / MIX OUT
- Use this electronically balanced low impedance (600 Ohm) 1/4-inch
TRS (Tip Ring Sleeve) jack when connecting the CR277 to your mixer or amplifier equipment.
Depending on the position of the MIX OUT (#1) switch, the jack will carry the signal from receiver
Channel B, or with the MIX OUTPUT switch set to "ON", the jack will carry the combined signal
from receiver Channel A and B.
3: Squelch B control - This control determines the maximum range of the CR277 Channel B
receiver before audio signal dropout. Although it can be adjusted using the supplied plastic
screwdriver, it should normally be left at its factory setting. See the “Setting Up and Using the
Concert Series System” section on page 6 in this manual for more information.
4: DC input - Connect the supplied 15 volt 350 mA power adapter here, using the strain relief as
shown in the illustration below.
WARNING:
Do not substitute any other kind of power adapter;
doing so can cause severe damage to the CR277 and will void your warranty.
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
5: Squelch A control
- This control determines the maximum range of the CR277 Channel A
before audio signal dropout. Although it can be adjusted using the supplied plastic screwdriver,
it should normally be left at its factory setting. See the “Setting Up and Using the Concert Series
System” section on page 6 in this manual for more information.
6: OUTPUT A
- Use this electronically balanced low impedance (600 Ohm) 1/4-inch TRS (Tip Ring
Sleeve) jack when connecting the CR277 Channel A receiver to your mixer or amplifier.
Guided Tour - CR277 Rear Panel
1
2 3 4 5 6
CR277
-