Samson 44-0 B, Монтаж и эксплуатация

Страница: 41 / 66

EB 2626-1 EN 9-1
Servicing
9 Servicing
The regulator does not require any mainte -
nance. Nevertheless, it is subject to natural
wear, particularly at the seat, plug and oper
-
ating diaphragm/bellows. Depending on the
operating conditions, check the regulator at
regular intervals to avoid possible malfunc
-
tions. Plant operators are responsible for
drawing up an inspection and test plan. De -
tails on faults and how to remedy them can
be found in the 'Malfunctions' section.
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
We recommend removing the regulator from
the pipeline before performing any mainte
-
nance or service work.
Risk of burn injuries due to hot or cold
components and pipeline.
Regulator components and the pipeline may
become very hot or cold. Risk of burn inju-
ries.
Î
Allow components and pipelines to cool
down or warm up to the ambient tem-
perature.
Î
Wear protective clothing and safety
gloves.
Risk of personal injury due to residual
process medium in the regulator.
While working on the regulator, residual
process medium can escape and, depending
on its properties, may lead to personal in-
jury, e.g. (chemical) burns.
Î
Wear protective clothing, safety gloves
and eye protection.
Risk of regulator damage due to exces-
sively high or low tightening torques.
Observe the specified torques when tighten -
ing regulator components. Excessive tighten -
ing torques lead to parts wearing out more
quickly. Parts that are too loose may cause
leakage.
Î
Observe the specified tightening torques
(see 'Tightening torques' in Annex).
WARNING !
WARNING ! WARNING !
NOTICE !