Samson 33-1, Монтаж и эксплуатация

Страница: 26 / 56

5-2 EB 2551-1 EN
Mounting and assembly
Mounting posi tion for
gases and liquids.
Not permissible
Fig. 5-1: Mounting position
Support or suspension
The plant engineering company is responsi-
ble for selecting and implementing a suitable
support or suspension of the installed regula-
tor and the pipeline.
Depending on the regulator version and
mounting position, the valve, actuator and
pipeline must be supported or suspended.
Do not attach supports directly to the regula-
tor.
Note
NOTICE !
5.2 Preparation for installation
Before mounting, make sure the following
conditions are met:
− The regulator is clean.
− The valve, actuator and all piping are
not damaged.
− Install a strainer upstream of the regula-
tor.
− The valve data on the nameplate (type
designation, valve size, material, pres -
sure rating and temperature range)
match the plant conditions (size and
pressure rating of the pipeline, medium
temperature etc.). See the 'Markings on
the device' section for nameplate details.
− The requested or required additional fit -
tings (see the 'Design and principle of
operation' section) have been installed or
prepared as necessary before installing
the valve.
Proceed as follows:
Î
Lay out the necessary material and tools
to have them ready during installation
work.
Î
Flush the pipeline before installing the
regulator.
The plant operator is responsible for
cleaning the pipelines in the plant.
Î
Check any mounted pressure gauges to
make sure they function properly.