Samson 3275A, Монтаж и эксплуатация, Страница: 22 / 52

4-4 EB 8314-1 EN
Shipment and on-site transport
b) Lifting the entire control valve
assembly
In order to lift an entire control valve assem-
bly, the slings attached to the valve body
must bear the entire load. The sling between
the lashing point on the actuator and rigging
equipment (hook, shackle etc.) must not bear
any load. The sling only protects the control
valve from tilting while being lifted. Before
lifting the control valve, tighten the sling.
Î
See associated valve documentation for
instructions on how to lift a control valve.
4.4 Storing the actuator
Risk of actuator damage due to improper
storage.
Î
Observe the storage instructions.
Î
Avoid long storage times.
Î
Contact SAMSON in case of different
storage conditions or longer storage
times.
We recommend regularly checking the actu‑
ator and the prevailing storage conditions
during long storage times.
Storage instructions
− When the valve and actuator are al-
ready assembled, observe the storage
conditions for control valves. See associ-
ated valve documentation.
− Protect the actuator against external in-
fluences (e.g. impact).
− Secure the actuator in the stored position
against slipping or tipping over.
− Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
− Protect the actuator against moisture and
dirt. Store it at a relative humidity of less
than 75 %. In damp spaces, prevent con-
densation. If necessary, use a drying
agent or heating.
− Make sure that the ambient air is free of
acids or other corrosive media.
− Observe permissible temperatures (see
'Technical data' in the 'Design and prin-
ciple of operation' section).
− Do not place any objects on the actuator.
Our after‑sales service can provide more de‑
tailed storage instructions on request.
NOTICE !
Note
Tip