Samon ONION LOADER SU2LS, Руководство и список запасных частей

Страница: 7 / 55

H5
www.samon.nl - info@samon.nl
V1-2018-ENG
20
4. Inspections before and during use.
WARNING!!!
Make sure that the tractor's engine has been switched off and the key has been removed from the ignition
before you carry out inspections of or maintenance on the SAMON Onion Loader.
4.1 Necessary inspections before using the SU2LS for the first time
•
Make sure all steps from chapter 5 are carefully followed up.
•
Check the length of the PTO shaft (see 4.2)
•
Check that all the wheel nuts are properly fixed. Always tighten the wheel nuts with a big cross-
key. Tighten the wheel nuts again after using the machine for two hours. Repeat this step each
time a wheel has been disassembled.
•
Check all points of 4.3.
4.2 Shortening the PTO shaft.
When the inspection before use reveals that the PTO shaft is too long then it can be shortened as follows:
•
Connect the machine to the tractor.
•
Position the PTO shafts so that they are as close as
possible to each other.
•
Measure distance "A" of the PTO shafts.
•
Measure distance "B" of the PTO shafts
(see the illustration for the measuring points).
•
Subtract length "A" from length "B" and add 10mm.
•
Shorten the PTO shaft by the result (see example).
Example of a calcuation:
A=400 mm
B=450 mm
B(450) - A(400) = 50 + 10
To be shorened by 60 mm