5
R. 10/20 816 809
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
2020_10_21-09:00
EN
BATTERY CHARGING AND INSTALLATION
GREASE FILLING
The battery is supplied partially charged. Before using the tool for the first
time, the battery should be fully charged in the charger.
Interruption of the charging process does not affect the battery.
To remove the battery (9), press the release button (10) and pull back the
power tool’s battery. Do not proceed too abruptly.
Make sure that the supply voltage is within the range specified on the
charger.
1. Plug charger into the socket.
2. Insert the battery into the charger. The indicator light on the
charger will change showing the status of the charging process.
Battery is charging (red light)
Charging completed (green light)
Red light flashing: battery damaged, stop charging and
replace battery
3. Disconnect charger from power source and remove the battery
from the charger after charging is complete.
DISASSEMBLING THE BATTERY
CHARGING PROCESS
INSTALLATION OF A GREASE CARTRIDGE
WARNING:
Charge the battery in a clean and dry place with
temperatures between 10ºC and 40ºC.The temperature of the
battery and charger may increase slightly during the charging
process.
!
The battery may not be fully charged if it is charged immediately after
being used for a long period. Allow the battery to cool to room
temperature before recharging.
1. Pull the pulling rod (13) out until it is fully extended and lock the rod
with the tab (14).
2. Unscrew the grease tube (12) from the gun body.
3. Remove the plastic cap from the grease cartridge and insert it into the
tube (12) with the open end first. Then remove the seal from the other
end of the grease cartridge.
4. Screw the grease tube back into the gun and tighten it securely.
5. Unlock the rod (13) from the grease tube and insert it into the tube.
6. Purge any air the gun may contain. See the section “Grease gun priming”.
7. Set the meter on the display to zero.
13
14
New grease cartridge
Plastic
cap
Tube
Twist
Tube
Pull-tab
seal
