SAMES KREMLIN Nanogun+ Airmix, Инструкция по эксплуатации

Страница: 81 / 96

81
Member of EXEL group
8.11.2. Procedure for changing from a flat spray to a round spray
To carry out this operation, the gun must be disconnected from any supply (product /
air / current).
Remove the flat spray :
• Loosen the cap nut (P/N: 910019358).
• Remove the cap (P/N: 130001435), if the injector does not come away at the same time, remove it too.
• Loosen the seat casing (P/N 910019359) while pressing the trigger.
• Remove the adaptor (P/N: 910019360) and the flat seal (P/N.: 900014821) located at the rear. Make
sure you do not lose or break the high voltage contact and the O-ring (P/N.: J3STKL014).
• Extract the first split ring (P/N: 900010164) inside the cap nut and remove the cap.
Install the round spray (hollow cone) :
• Put the flat seal in place (P/N: 900014821) and the hollow cone adaptor (P/N: 900011504), Make sure
you do not lose or break the high voltage contact and the O-ring (P/N.: J3STKL014)
• Add a little dielectric grease to the HV contact and a film to the seat casing thread.
Make sure you do not lose the distribution pad carbide (P/N: 999469300) at the front of the part
• Screw the seat casing fully onto the barrel while pressing the trigger.
• Add a film of dielectric grease to the threading at the front of the seat casing; make sure you do not get
any on the distribution carbide pad.
• Screw the injector fully on the seat casing.
• Insert the cap into the cap nut and put the retaining ring back in place.
• Put the cone in place.
• Add a film of grease on the barrel threading.
• Add a film of grease on the barrel threading.