Index revision : A
33
7140
6.3. Replacement
6.3.1. Procedure C1: Replacement of the antistatic toothed belt
WARNING : Before removing the belt, it is necessary to secure the counterweight
To do so, the projectors mounted on the
Inorecip V
have been removed from the booth:
Move the altitude carriage down to altitude until it touches the lower stop.
• Move the altitude cart down until it touches the lower stop.
• Secure the counterweight carriage by placing a cleat (100x100) of a size adapted to the
height between the counterweight carriage and the base of the Inorecip V.
• Slacken the belt by loosening the two tensioning screws (
).
• Note the position of the locking plates on
the altitude carriage and on the counte-
rweight carriage as they should be reas-
sembled in approximately the same
position, then loosen the upper (
A
) and
lower (
B
) locking plates and remove the
belt.
• Proceed in the reverse order for reassem-
bly.
• Adjust the tension of the new belt (
).
(
A
)
(
B
)
