SAMES KREMLIN
Page 7
Manual : 573.182.112
Stages :
1 - Priming
2 - Working
3 - Partial
flushing
The label indicates also the air pressure adjustment on the motor of the pump.
: Low pressure
: Higher pressure
FIRST START UP
CAUTION :
This pump has been checked and tested with water in our factory.
During the first start up, a flushing of the circuits with solvent is required
to ensure a good operating of this pump.
Be certain the gun trigger is released and hoses are properly interconnected.
Insert BASE drain rod and CATA hose into waste containers.
Insert suction rod of BASE fluid section into SOLVENT container.
Fill up with SOLVENT the CATALYST container.
Be certain the manifold hand levers are in the PRIMING position.
Adjust the black regulator 'Air motor' (9) between 0.5 and 2 bar / 7 and 29 psi.
Both components must flow freely from BASE drain rod and CATA hose into waste containers.
Once drained the circuits, insert the drain rod into the solvent container and the CATALYST hose
into the other container. Make the materials circulate until air bubbles are evacuated.
Unscrew the air regulator (9), then empty the solvent of the CATA container.
Prepare the materials :
Fill up a container with Material A (BASE),
Fill up the pump container (Maximum 10 liters / 2.6 US gal) with material B (CATALYST),
Fill up a container with Flushing Solvent S.
Insert BASE suction rod (Ø 16) into BASE container and the 'BASE' rod into a waste container.
Insert SOLVENT rod into solvent container.
Insert 'CATA' hose into a waste container.
PRIME
(Stage 1)
to evacuate solvent into fluid sections, then insert BASE drain rod into BASE
container and CATA hose into CATA container.
