SAMES KREMLIN AIRMIX 15-C50, Руководство пользователя

Страница: 71 / 80

SAMES KREMLIN - 3 - N° : 578.051.120-UK-1802
Guards (air motor cover, coupling shields, housings …) have been designed for
safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards
Start up procedure :
- Ground the pump.
-
If the pump is a cup lub one, fill the wetting cup (S) with T lubricant (P) or with an appropriate
cleaning solvent.
- Unscrew the air regulators (D and F),
- Interconnect the equipment with the air pressure network (clean and dry air - P < 6 bar / 87 psi)
Install a water drop, if it is necessary.
- Connect all the hoses (M& N) as well as the gun (O).
- Remove the gun air cap by unscrewing the cap ring and nozzle (only in case of an Airmix® gun).

FLUSHING WITH SOLVENT
- Immerse suction rod (L) into solvent-filled container.
- Open motor air pressure supply - valve (H).
- Point the spray gun, not supplied with air, towards the material container and press the trigger.
- Increase
gradually the air regulator (D) so that the pump runs slowly (Proportionally to pressure
ratio). When material flows out regularly, release the trigger.
- Drain all solvent from the pump.

PRIMING WITH MATERIAL
- Immerse suction rod (L) into material container.
- Point the spray gun, not supplied with air, towards the material container and trigger the gun until the
material flows out regularly.

WORK
- Reinstall the ring, the aircap and the nozzle (only in case of an Airmix® gun) on the gun.
- Adjust air regulator (D) to get the appropriate material pressure and flow rate.
-
Gradually open air regulator (F) to adjust spraying air to obtain the required spray pattern.
2-2 PUMP SUPPLIED IN GRAVITY

CAUTION: The pumps can be supplied in gravity but not in filling.
Interconnect the pump fluid inlet with the gravity cup supply hose and start up the pump as previously
indicated.