Doc.-ID: 220316-PT08BA-ES-ExCam XI410_en_rev.00.docx, Page 20 of 28
6
Network access and visualization
The most important procedures of initially starting the camera are described below. A
detailed software description can be found on the supplied USB stick and in the Help
menu in the PIX Connect software under
Help → Documentation
. Alternatively, the
software can also be downloaded from the Optris website at the following link:
6.1
Minimum system requirements
• Windows 7, 8 or 10
• USB port
• Hard disk with min. 30 MByte free storage
• Minimum 128 MByte RAM
6.2
Set up installation / first use
All drivers are loaded automatically by the Windows operating system. No driver installa-
tion is necessary. The software starts automatically in the installed language.
1. Connect the supplied USB stick to your PC
2. Start the Setup.exe. Follow the instructions of the wizard until the installation is fin-
ished. After installation, you will find the software on your desktop (as a program icon)
and in the start menu: Start \ Programs \ Optris GmbH \ PIX Connect
3. Select the desired language in the menu Tools
→ Language
6.3
Allocating IP adress
The ExCam XI410 is designed for use in an Ethernet network and requires an IP address
for access and control.
Software configurations
based on OEM operating instructions (Optris)
Ethernet setup (point-to-point connection)
After you have connected the Ethernet cable to the camera and the PC, you first have to
make the network settings on the PC.
The devices are delivered with the following factory settings:
IP-address camera: 192.168.0.101
IP-address PC: 192.168.0.100
Port-number: 50101
1.
