Samcon ExCam Series, Руководство по установке

Страница: 7 / 24

Doc.-ID: 180731-PT08BAU-SS-Ex Installation Manual rev.00.docx, Page 7 of 24
3 General safety instructions and special conditions
Attention!
Cameras of the type T08 ExCam are not suitable for use in zones 0
and 20. The ambient temperature, temperature class, and explosion
group
stated on the enclosure’s type plate, must absolutely be ob-
served! The customer is not allowed to make any alterations inside or
outside at the camera and must only be used for the intended purpose
and in an immaculate condition.
Attention!
Only original parts from SAMCON Prozessleittechnik GmbH may be
used for repair. Repair works affecting the explosion protection may
only be carried out in accordance with the regulations applicable in
the country of use and only by SAMCON Prozessleittechnik GmbH.
Attention!
Prior to installation, please consider external sources of heat or cold!
The permissible temperature range must absolutely be observed!
Attention!
If you use the ExCam in the mining sector with a “high” risk of me-
chanical hazard, you must provide an appropriate device ensuring
protection of translucent components (protective grille, etc.)
Attention!
Observe the warnings given on the type plate!
Note: Depending on the classification of hazard areas, a work approv-
al must be obtained. When adjusting the camera, you shall prevent a
potentially explosive atmosphere!
The use in hazardous areas with regard to temperature and dust lay-
ers is defined in the respective national regulations.
Prior to the first use, you should test the camera corresponding to the instructions
given in the chapter Commissioning.
Please observe the national safety regulations and regulations for prevention of
accidents, as well as to the safety instructions given below in this User Manual!