Samcon ExCam Series, Руководство по установке

Страница: 19 / 24

Doc.-ID: 180731-PT08BAU-SS-Ex Installation Manual rev.00.docx, Page 19 of 24
7 Maintenance/ Modification
The applicable regulations for the maintenance and servicing of electrical devices in po-
tentially explosive atmospheres must be observed. The necessary maintenance intervals
depend on the operating condition and should be individually determined by the user.
The maintenance tasks especially include examination of parts on which the ignition pro-
tection depends (e.g., proper condition of the housing, seals and cable entry points).
All necessary maintenance measures should be initiated and/or executed.
8 Repair
Repair must only be carried out with original spare parts of SAMCON Prozessleittechnik
GmbH. Damaged pressure-resistant housings must be replaced completely. If in doubt,
return the component(s) to SAMCON Prozessleittechnik GmbH.
Repair affecting the explosion protection must only be carried out in accordance with na-
tionally applied regulations by SAMCON Prozessleittechnik GmbH or by an authorised
electrical technician authorised by SAMCON Prozessleittechnik GmbH. Rebuilding of or
alterations to the devices are not permitted.
9 Disposal/ Recycling
When disposing of the device, observe the regulations applicable in your country.
10 Drawings
Drawings of the devices can be taken from the data sheets. DXF, DWG drawing files with
the relevant dimensions, as well as 3D models (.pdf, .step. IGES, etc.), including the
ones of all accessories are available at
www.samcon.eu . If you require additional tech-
nical information, please contact us at support@samcon.eu .