13
OPERATOR'S MANUAL
REAR DISC MOWER
XT
❑
to catch machines, pick ropes of adequate length, so that the angle between them is no greater than
120°, and the angle between the strand and the vertical is no greater than 60°
,
❑
collapsible parts should be blocked in transport position,
❑
when relocating the mower onto another vehicle, there should be no unauthorized personnel
permitted to remain within the danger area,
❑
the mower should be protected from shifting on the vehicle's trailer.
WARNING!
Securing manouvering area and transport of the mower is the responsibility of a
person who does it.
Fig. 6.
Location of centre of gravity
Tab. 4.
Location of centre of gravity
Dimension
[ft in / mm]
Mower type
XT 390
A
8
′
3
″
/ 2520
B
11
′
6
″
/ 3500
C
2
′ 1½″
/ 650
D
2
′ 3½″
/ 700
E
2
′ 7½″
/ 800
F
1
′ 7″
/ 480
4.5.
Operating parts
❑
Prior to operating the mower check the knife, knife mountings and the knife holder condition.
❑
Worn or damaged knives, knife mountings or knife holders should be replaced immediately with
new ones.
WARNING!
During replacement of working parts, it should be used personal protective
gloves.
4.6.
PTO shaft
❑
Before operating learn provisions found in bar manufacturer's manual placed on the bar.
❑
Use only the mower's manufacturer recommended PTO shafts featuring guards in good technical
condition.