26
TORNADO
ROTARY SNOW BLOWER
OPERATOR’S MANUAL
7.
DISMOUNTING AND WITHDRAWAL FROM USE
NOTE:
Before performing any repairs and withdrawal from use the machine must be
disconnected from the tractor.
7.1.
Repair
Before repairing or assessing whether the machine is still serviceable, the machine should be
carefully cleaned of dirt, mud and plant remains.
After checking nuts and bolts, proper slack in joints, gears we can assess if the machine is still
serviceable. Worn out bolts, pegs and pins should be replaced.
Once the machine is repaired perform the following:
❑
make sure that all elements are installed properly,
❑
install the removed guards,
❑
check whether screws and nuts are tightened,
❑
once all the guards are installed, perform a warm-up start to make sure the repaired machine
operates properly.
7.2.
Disassembly and withdrawal from use
In case of partial wearing of rotary snow blower, replace any worn parts. Prior to this, clean and
wash the machine. If need be drain oil into a tight tank or protect connecting nozzles. Next replace any
worn parts with new genuine ones.
Pay particular attention at any mounting and dismounting works and use drawings provided in
spare part catalogue. Store damaged or worn parts in restricted area and then deliver to a scrap yard.
NOTE:
When mounting and dismounting, please remember about personal protection
as well as environmental protection means.
NOTE:
When unhitching the machine pay particular attention to additional threat such
as crush or cut. Special protective equipment must be used: gloves, protective
clothing, glasses etc. Pay attention not to allow the machine lose its stability
and therefore protect it with supports.
7.3.
Withdrawal from use
If the machine cannot be repaired anymore, it should be withdrawn from use. Prior to this, clean
and wash the machine. Firstly, drain oil from hydraulic assembly and handle it for utilization. Then
dismount rotary snow blower and remember that parts should be segregated according to kind of
material used and delivered to a scrap yard or for utilization.
7.4.
Environment
❑
Rotary snow blower is a fully natural environment-friendly product.
❑
95% of parts used in the blower are recyclable.
❑
Materials used for packaging are 100% recyclable.
❑
Worn machine parts and packaging should be utilized in conformity with local natural environment
protection regulations.
