SaMASZ KDT 220, Руководство оператора

Страница: 9 / 52

9
OPERATOR’S MANUAL REAR DISC MOWER KDT
3-point linkage frame ( 1) enables attachment of the mower to tractor’s 3 -point linkage. Drive from
tractor’s rpm is transmitted through intersecting axis gear ( 3 ) on the cutterbar ( 4) . On the cutterbar,
there are discs with two knives each. Apart from that, drive from tractor’s rp m through
V-belt drive
( 8 )
and PTO shaft ( 9 ) is transmitted to tine conditioner ( 7 ). Hydraulic cylinder ( 2) is used to adjust
the mower to working position. It is supplied from outer hydraulics of the tractor. Main frame, on which
the cutterbar (
4 ) is situated, is supported by the springs ( 2 ). Swath guides ( 5) are mounted on the safety
curtain ( 6 ).
3.3.1. Rear disk mower with roller condioner
Fig. 3c. Parts of SaMASZ rear disc mower with tine conditioner
1 – 3-point linakge frame
2 – Hydraulic cylinder with support springs
3 – Axis gear
4 – Cutterbar
5 – Swath guides
6 – Roller condioner safety guard
7 – Roller conditioner
8 – V-belt drive
9 – Roller condioner PTO shaft
10 – Support legs
3-point linkage frame ( 1 ) enables attachment of the mower to tractor’s 3 -point linkage. Drive from
tractor’s rpm is transmitted through axis gear ( 3 ) on the cutterbar ( 4 ). On the cutterbar, there are discs
with two knives each. Apart from that, drive from tractor’s rpm through
V-belt drive
( 8 ) and PTO shaft
( 9 ) is transmitted to roller conditioner ( 7 ). Hydraulic cylinder ( 2 ) is used to adjust the mower to working
position. It is supplied from outer hydraulics of the tractor. Main frame, on which the cutterbar is
situated, is supported by the springs (
2 ). Swath guides ( 5 ) are mounted on the safety guard.
3.4. Equipment and spare parts
The mowers are sold with the following standard equipment:
❑
warranty card,
❑
operator's manual with catalogue of spare parts and declaration of conformity,
❑
cutting knives (additional set),
❑
frame mounting key,
❑
PTO shaft,
❑
spray paint (150 ml / 5.3 uk fl oz).
Optional extra equipment:
❑
warning triangle,
❑
topping plates / double topping plates,
❑
cutting disc with instep (set),
❑
double swath guide (only KDT 341),
❑
two swath cutterbar configuration (only KDT 341).
1 2 3
4
5 7 8 9 10