SaMASZ KDT 220, Руководство оператора

Страница: 41 / 52

41
OPERATOR’S MANUAL REAR DISC MOWER KDT
6.11.4. After-season maintenance and storing of machine
At the end of mowing season the following shall be performed:
❑
lower the mower’s cutterbar onto the ground,
❑
take the PTO shaft extension out of the tractor rpm or dismount the complete PTO shaft and install
it into corresponding holder at the 3-point linkage frame,
❑
unmount hydraulic and electrical hoses from the tractor and hang them onto corresponding holders
on the 3-point linkage frame,
❑
unmount the mower from the tractor (reverse procedure as in case of attaching the mower to
the tractor item 5.1), and then drive the tractor away.
Mower should be stored in standstill position, so it is supported onto supporting leg and the cutterbar.
It is recommended to store the set on paved ground, preferably in roofed places, inaccessible to
unauthorized personnel or animals.
If the machine is stored for a long period of time before first operation, its technical condition should
be examined and special attention should be paid to the hydraulics and the drive. Paint the area where
the paint is missing, hydraulic hoses checked and lubricated.
Mower should be stored in paved, dry places, protected against precipitation. In order to minimize the
space necessary for storage the mower may be stored in a vertical position but always on paved
surface. Storing the mower on an unpaved surface may cause the mower to lose stability and turnover.
NOTICE:
When stored for long time (e.g. in winter season), the machine should be in an upright
position on paved surface (with closed cylinders). Storing the mowe in a horizontal
position may cause faster wearing (rusting) of the cylinder from the inside (through
vent valve) by being penetrated by moisture from the air.
Additionally:
❑
remove any traces of rust and paint the area,
❑
check the oil level in the angle drives and the cutterbar (Section 7). If leaks are discovered, they
should be repaired immediately and lost oil replaced. If water in oil is discovered, immediately
change the oil as it could cause corrosion of internal mechanisms such as gear wheels, bearings,
or shafts, and cause breakdowns,
❑
periodically inspect the mower and lubricate moving parts in order to protect them from corrosion
which adversely affects the proper operation of the mower,
❑
check hydraulic hoses regularly. Replace any damaged or old hoses. In any case, you should
replace hoses that have been in use more than 5 years from the date of their manufacture printed
on the hose.
7. LUBRICATION
7.1. Cutterbar
Refilling the oil of the cutterbar is done through the inlet A ( Fig. 36 ). Proper oil level is 0.2" - 0.3" from
the cutterbar bottom. Oil capacities are given in table below.
In order to drain oil out of the cutterbar, firstly lift the mower up onto tractor's links and then dismount
the cutterbar closure as shown in
Fig. 36 and tilt the cutterbar so, as to enable the old oil to drain. Oil
drained out of the cutterbar should be disposed in a proper manner.