Operator's manual
Trailed disc mowers
KDC 300 S/W; KDC 340 S/W
KDC 300 ST/WT; KDC 340 ST/WT
- 17 -
NOTE:
Any assembly used for the mower repair should hold all warning decals
provided by the manufacturer.
5.
OPERATION
5.1.
Mounting mower on tractor
Mower should be mounted on tractor with use of 3-point linkage frame. Pins (P) of mower's
hitch should be connected to links (C) on tractor and then secured with pins as provided on
Figure 7. Next lift up support leg (S) and secure it with pin.
Fig. 7. Mower mounted on tractor
5.2.
Preparing mower for transport
In order to prepare mower for transport:
1.
With use of hydraulic cylinders get mower behind tractor.
2.
Lift mower's side guards to vertical position (Fig. 8a).
3.
Lift cutterbar by means of cylinders.
4.
Close hydraulic valves located nearby cylinders (Fig. 8b).
5.
To meet safety precautions concerning transport on the public roads and valid regulations the
mower should be equipped with the following portable warning-light plates, consisting of panel
mounted in the upper guard socket (to be ordered optionally). Panel consists of warning plate
with mounted white light on the front and red one and reflexive light facing the rear.
6.
When maneuvering, pay special attention to area around tractor-mower aggregate.
7.
When driving in the evening electric installation should be connected to lights mounted on
panels.
NOTE:
When transporting the machine, levers of cut-off valves must be closed.
Thanks to it, the mower is protected from accidental dismantling on
unexpected motion of both the tractor and the mower – in worst case, it
might cause cracks to hydraulic hose and lead to an accident.
S
P
C
