SaMASZ FISHER, Руководство оператора

Страница: 9 / 28

9
OPERATOR'S MANUAL HYDRAULIC FRONT-LOADER EXTENSION
ARM FISHER
❑
For any break in the machinery operation turn off the drive.
❑
Periodically check bolts and other fasteners. Do not operate with damaged or worn fasteners.
❑
Do not operate the machine after dusk.
❑
Do not leave the aggregate on slopes without any protection.
❑
Do not leave the tractor's cabin or loader when driving.
❑
In the event of a serious failure, stop the machine's drive, turn off the vehicle's engine and take out
the ignition key. Then call for technical service, and if an accident (in this case: road accident)
occurs, respect first aid rules and contact responsible authorities.
❑
Do not transport any persons on the machine.
4.2. Transport
❑
Have all persons (children in particular) not involved in the actual work with the machine move
away from the area and limit the zone where the operations are to be carried out.
❑
For transport convert the machine to transport position (it. 5.3).
❑
Before the vehicle mounted machine is set in its transport position, make sure that all rotating
parts have come to a complete standstill.
❑
Do not drive over 25 km/h.
❑
Drive slower if road conditions are poor, especially on irregular surfaces or steep slopes.
4.2.1. Moving machine onto another vehicle for transport
The driver and the carrier are responsible for the machine's transport safety. Any equipment and
parts must be secured for transport. To put the machine onto another vehicle in a safe way, please obey
the following rules:
❑
Grab machine by any lifting devices only in places indicated by hook sign ( Fig. 5 ),
❑
For machine lifting, use only lifting devices with hoisting capacity larger than machine
’
s weight
shown in data plate. This also applies to ropes and chains used for lifting,
❑
Do not lift if transport belts, belt suspensions, ropes are damaged. Whenever damage to these
parts occurs, replace with new ones,
❑
When mounting slings, chains, handles etc., always set the machine's centre of gravity properly
(
Fig. 4 ),
❑
To safely support the machine, use belts of adequate length so that the angle between them is no
greater than 120°, and the angle between the strand and the vertical is no greater than 60°,
❑
Collapsible parts should be blocked in transport position,
❑
No one should be within the range of action of the machine lifting when any transporting operations
are being carried out,
❑
The machine should be protected from shifting on the vehicle's trailer,
❑
Before transporting in the given position ( Fig. 5 ), check whether the rotary arm is secured with pin
( S ).