Salvis Master VisionPRO, Руководство по сборке

Страница: 41 / 72

Assambly instruction Cooking station 41 / 72
Screw M4x10, hexagon
socket WAF 2.5 mm, art. no.
02221807
Removing the generator cover panel
.
Remove the screw.
.
Release the cover panel at the bottom.
Air flow
D
After connecting all electric supply lines,
re-attach all removed cover panels.
D
Improper air flow leads to overheating and
failure of the induction generators.
4.1.5 Removing the bain marie, pasta cooker water drain cover panel
Screw on handle
Hexagon screws M5x10,
WAF 8 mm, art. no. 003743
.
Remove the screw on the handle.
.
Remove the handle.
.
Remove the screws on the cover panel.
D
Support the cover panel when removing
the last screw.
.
Remove the cover panel.
4.2 Installing the gas/water supply/drain lines
This work is only necessary if the top and base units were separated.
D
Supply and drain lines must not be in direct contact with heat sources (e.g. oven). The lines
must be installed with sufficient spacing to the heat source.
.
Connect the water drain of the installation module to the ball valve.
.
Connect the water supply hoses to the ball valve/mixer tap.
.
Install the water drain hoses from the top unit/drain tap to the installation compartment with
downward gradient.
.
Install the gas supply lines from the top unit to the installation compartment.
Installing the connection between top and base units