Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
8
2 Install Instructions
1. Carefully unpack the SE3001 control box, chopping head and accessories. See below for a complete list of parts.
Please contact us first and do not use the SE3001 if any of the items appear damaged or missing.
SE3001 Control Box
SE3001 Optical Chopping Head
(1x) 10-slot chopping blade
(6x) M3 x 4 Hexagon socket button head screws for blade retention
(6x) M3 washers for blade retention
M2.5 x 4 set screws for hub retention
5/64" (2.0mm) Alley Key for blade replacement
0.05" (1.27mm) Alley Key for hub alignment
1 meter 6P6C double-ended cable
1 USB Cable
1 BNC Cable
1 Power Supply Line Cord: 110/250 VAC with SE3001
(1x) CD.
2. Install the blade.
Lay the chopping head down and put the blade on the blade hub.
Make sure the blade do not touch the photoelectric door and spin smoothly. If the blade touch the
photoelectric door, adjust the position of the chopper blade hub using the 1.27mm Alley Key until the blade can
spin smoothly.
Align and fix the blade onto the blade hub using 3 M3*4 round head hexagon screws and 3 M3 washers.
Make sure the blade can spin freely again when the blade is fixed to the chopper blade hub tightly.
3. Use the 6P6C cable to connect the Optical Head on the rear panel of the SE3001 Control Box and the cable
connector on the chopping head.
4. Mount the SE3001 Control Box and the SE3001 Optical Chopping Head on a stable surface. Attach the power
supply line cord to the SE3001 and plug into an AC outlet. Turn the power switch on and then you can use it.
