14
Tel: 886.909 602 109 Email: [email protected]
2.5.4.
Instrument Symbol
Instrument symbol shown in the picture (yellow label) means that the maximum input power of test port 1 is +27dBm; the maximum
input DC level is 25VDC. Do not connect signals beyond this range to the port in use, which could burn the instrument!
2.6.
Battery
S3101 Cable & Antenna Analyzer is equipped with a rechargeable lithium-ion battery with a large capacity with operating time of up
to more than 8 hours for S3101A and 4 hours for S3101B (typ.). In order to assure the service life, the battery shall be taken out of
the battery compartment in transport and long-term storage. Buying stand-by batteries of the same model with the original one is
recommended to avoid test interrupt owing to low battery if long-time field test is performed.
S3101 Cable & Antenna Analyzer is easy to install or replace the battery, which is as shown in the below figures.
Figure 2.7 Battery Installation or Replacement Procedures
Moreover, the charging time for a fully depleted battery is approximately 4h.
2.7.
Turn On/Off
Press the yellow power switch
at lower left corner of the front panel of S3101 Cable & Antenna Analyzer for about three
seconds, after beep from the buzzer, release it, the Analyzer displays startup screen.
S3101 will take about 20 seconds to boot the start system and perform a series of self-test program, then the instrument enters the
Pull down
battery cover
Open battery
cover
Install / pull out the
battery
Close battery
cover
Push up battery
cover