Tel: 886.909 602 109 Email: [email protected]
9
2.2.2 Installation Instructions
Figure 2.4 Screw mounting position diagram
As shown in Figure 2.4, the 6 screws at "2" are used to fix the turret bracket on the turret; the 6 screws at "1" are used to fix
the radar main unit to the turret bracket; the screws at "3" are used for The turntable is fixed to the whole machine bracket.
Note:
1) Please prepare a set of hex driver (see Fig.5);
2) It is recommended to install more than two people;
3) In order to improve the angle measurement accuracy, please adjust the bottom level of the turntable before
installation.
Figure 2.5 Hex wrench
2.3 Precautions
1) Please keep a certain distance from the radar to prevent personal injury caused by sudden rotation of the radar;
2) Be sure to ensure the level of radar installation;
