12" Wide
Standard
Lockers
–
64
000 Series
Four Tier Installation Instructions
Thank you for selecting Salsbury’s
12" wide
standard four tier lockers. These instructions are intended to assist you in assembling the lockers. Note that a 6 feet high locker is shown.
Hole locations on the 5 feet high locker are different. Assembly of the various locker components will be with #10 - 24 x 3/8” long slot less screws and #10 nuts (provided). Loosely
fasten a screw and a nut into every set of mating holes with the screw heads positioned on the outside of the locker or on the exposed surface.
One Wide Locker Assembly
Step 1
: Attach the top shelf and bottom shelf to the back panel.
Step 2:
Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and three compartment dividers to the assembly from
Step 1.
Step 3:
Attach the second side panel and the right rear leg to the assembly of Step 2.
The locker chassis is now complete.
Step 4:
Attach the pre-assembled door frame onto the assembly of Step 3.
Step 5:
Tighten all fasteners checking for squareness of the locker while tightening.
Attach optional sloping hood, end bases or front base (see pages 4 and 5).
Step 6:
Place the locker in the installed location and anchor to the floor, wall, or to
both. Individual job conditions will dictate the type of fastening anchors to use (not
provided).
Step 7:
Fasten all lockers in a row together by installing fasteners provided through
the side panels. Installation is now complete.
