Salda SMARTY XV Series, Руководство пользователя

Страница: 17 / 48

DE | 17 SMARTY XV v2019.06
18.7. WARTUNG DES SCHALTNETZTEILS
• Schraube an der Vorderseite lösen;
• Nach dem Lösen der Stromversorgung heben Sie diese an, um den unteren Stecker (2-3) herauszuziehen.
• Die Stromversorgung befindet sich unter der Schutzabdeckung. Bitte entfernen Sie die Abdeckung, um sie zu wechseln (4-5). Lösen Sie an -
schließend die Stromversorgung von der Basis (6-7).
• Führen Sie die Montage in umgekehrter Reihenfolge durch.
• Die Anschlüsse sind entsprechend der Anschlussstelle gekennzeichnet, daher bitte auf die Kennzeichnung achten.
1.
2. 3.
4. 5. 6.
7.
19. DEVICE CONTROL
Ventilation unit can be controlled using a remote control, web interface via MB-Gateway and building management system. More information about
the possibilities of controlling is provided in the table below.
MB-G WIFI + SALDA AIR app Stouch FLEX MCB SA-Control MB-Gateway BMS
+ + + + + Modbus RTU
19.1. DESCRIPTION OF THE UNITS FUNCTIONS
All functions indicated in this section are installed in the software of the control board. However, operation and control of the device depends on
the following:
Selected control panel. Full functionality and configuration possibility can be assured only by MB-Gateway web interface SA-Control, SALDA AIR
app.
Connected external devices: external heaters, dampers, sensors and etc. (see the description of the acquired air handling system).
Internal components of the device: type of heat exchanger (plate or rotor), integrated dampers, sensors and etc. (see components of the chosen
device).
Control board type.
Air Handling Unit uses MCB board.
The unit can be configured only with SA-Control remote con trol panel, MB-Gateway web application or SALDA AIR app.
The following control board functions can be fully con trolled only with SA-Control remote con trol panel, MB-Gateway web
application or SALDA AIR app. In case of Stouch remote con trol panel use the description of remote control panel functions
for MCB control board.
19.2. SYSTEM MODES
Stand-by;
Building protection;
Economy;
Comfort.
In Stand-by mode the system is shut down for a permissible period (based on the Stand-by mode blocking function settings).