7
Smarty 2X/3X V
www.salda.lt
• Maintenance should be performed only by experienced and trained staff.
• The fan should be inspected and cleaned at least once a year.
• Be sure the fan is disconnected from power source before performing any maintenance or repair.
• Observe staff safety regulations during maintenance and repair.
• The motor is of heavy duty ball bearing construction. The motor is completely sealed and requires no lubrication. Supplied air fan from X15, X2, X4.
Extract air fan from X16, X2, X4.
• Detach fan from the unit.
• Impeller should be specially checked for buil-up material or dirt which may cause an imbalance. Excessive imbalance can lead to accelerated wear
on motor bearings and vibration.
• Clean impeller and inside housing with mild detergent, water and damp, soft cloth.
• Do not use high pressure cleaner, abrasives, sharp instruments or caustic solvents that may scratch or damage housing and impeller.
• Do not plunge the motor into any fluid while cleaning impeller.
Dirty filters increase air resistance, airflow into the room.
Smarty 2X V
Smarty 3X V
Remowing Smarty 2X V filters:
key loosened and removable product
doors, removable filters. Uses G4 / (F7 - optional) filters.
Remowing Smarty 3X V filters
: opening filter cover (pulling the strap),
retractable filter. Uses G4 / (F7 - optional) filters.
Unplug unit from mains before opening the door (discon-
nect the power plug from the outlet or if there is a two-pole
automatic circuit breaker installed – disconnect it as well.
It is necessary to ensure that it won’t be turned on by third
parties) and wait until the full stop of the fans (for about 2
min.).
Smarty 2X V
Smarty 3X V
Changing filters, filters reload timer control.
Description
of remote control panel functions is provided in the remote
control panel technical documentation or on the website
www.salda.lt.
Allowed to operate the unit without filters!
It is advisable to change the filters every 3 - for 4 months,
or according to their testimony timer remote control.
