Salda Smarty 2R VE, Руководство пользователя

Страница: 21 / 50

21
Smarty 2R VE
www.salda.lt
• Easy user‘s menu for sound, temperature, stand-by mode and CO
2
level settings; Stouch control panel sets CO
2
only for its own control, when CO
2
sen-
sor is connected to the Stouch!!! It doesn’t set limits of CO
2
on the control board.
• Fast button for setting maximum speed;
• Display of set supply air temperature;
• Selected speed LED indication;
• “Child safety feature” - locks the controller.
Description of elements
B1
On/Off
B2
Fan speed selection
B3
Temperature selection
B4
Increase
B5 Maximum fan speed for limited time (boost)
B6 Decrease
S1 Segment display
L4-L7 Fan speed indications
Alarm! Extract fan failure
Alarm! DX cooler failure
Alarm! Fire
Alarm! Supply fan pressure protection. System stopped.
Alarm! Extract fan pressure protection. System stopped.
Alarm! Internal system error.
Alarm! Heater manual protection. Boosting.
Alarm! Preheater manual protection. Boosting.
Elements Coomand Action Indication
B1
L1
Switch on
Press down for 2 seconds
B1
L1 lights on.
B1
L1
Switch off
Press down for 2 seconds
B1
L1 lights off.
L1
Switch off
Press any button. L1 flashes slowly in sleep mode.
B2 B4 B6
L2
Set fan speed
Touch B2. L2 lights on. Speed is adjusted by touching elements B4 and B6
B3 B4 B6
L3
Set temperature
Touch B3. L3 lights on. Temperature is adjusted by touching elements B4 and B6
B4 B6
L4-L7
Change value of se-
lected setting
Increase by touching B4,
decrease by touching B6
Numbers change in the segment display. L4, L5, L6, L7 shows selected fan
speed.
B4 B5 B6
L2
Switch on/off the in-
tensive ventilation
(boost)
2 sekundes palaikyti B5.
L2 is blinking. Split screen shows remaining time in seconds (if there’re more
than 600 sec. then - in minutes). Time can be adjusted by pressing B4 and B5
(in time of processing the function).
Maximal BOOST time: 300 minutes (5 hours).
Note: Time can’t be adjusted on PRV controller. If unlimited BOOST time is set
on PRV controller, then split screen shows “
---
“.
B1 B4 B6
L4-L7
Review and cancel
alarms
Press B2 and B3 for reset-
ting
By pressing B1 faults are
temporary not shown.
In case of failure L4, L5, L6, L7 are blinking and failure codes appear on split
screen (
A.01
,
A.02
and etc.). List of errors can be reviewed by pressing B4
or B6. After clearing fault signal remote controller returns into initial state. By
pressing B1 faults are not shown for one minute, thus permitting to adjust tem-
perature and fan settings.
Note: it’s strictly forbidden to clear a fault without removing its cause. This must
be performed by the service representatives or maintenance personnel.